LED Light Strips Features and Maintenance Methods

LED light strips are a kind of LED products that people like to decorate. What are the characteristics of LED strips and what should be paid attention to when repairing LED strips? Let's take a look!

LED light strips specifications and features

LED light strips are generally round two-line, round three-line, flat three-line, flat four-wire, etc.;
LED strips are available in red, green, blue, yellow, white, and colorful.

LED light strips features:

1. The LED strip is soft and the LED strip can be curled like a wire.
2. LED strips can be cut and extended.
3. LED light strip bulb and LED strip circuit are completely covered in flexible plastic. LED strips are insulated and waterproof, and LED strips are safe to use.
4. LED strips are weather resistant.
5. The LED light strip is not easy to be broken, and the LED light bar LED light bar has a long service life.
6.LED light strips are easy to make graphics, text and other shapes; currently LED strips have been widely used for decorations and lighting in buildings, bridges, roads, gardens, courtyards, floors, ceilings, furniture, cars, ponds, underwater, advertising, signs.

Matters needing attention when repairing LED strips

1. LED strips need anti-static

Because the LED is a static-sensitive component, if the anti-static measures are not taken when repairing the LED strip, the LED will be burned out and waste. It should be noted here that the soldering iron must use an anti-static soldering iron, and maintenance personnel must also take anti-static measures (such as wearing static rings and anti-static gloves).

2. LED light bar can’t continue to heat

LED strips have two important components, LED and FPC. LED strips supplied by led light strips supplier are products that cannot sustain high temperature. If the FPC continues to heat up or exceeds its temperature, it will cause the FPC's cover film to foam, which will directly cause the LED strip to be scrapped. At the same time, LEDs cannot sustain high temperatures. After a long time in high temperature, the LED strip chip will be burned out at high temperatures. Therefore, the soldering iron used in the maintenance of the LED strip must use a temperature-controlled soldering iron to limit the temperature to a range, and it is forbidden to change and set it at will. In addition, even if this is the case, it should be noted that the soldering iron should not stay in the pin position of the LED light strip for more than 10 seconds during maintenance. If this time is exceeded, the LED light strips chip is likely to be burnt out.

3. LED light strips prevent short circuit

Many LED strips are bad because there is a short circuit at the foot. Be sure to find out the real cause of the LED strip before repairing. Otherwise, after rushing to replace the defective LED strip, the chip of the LED strip will continue to be broken by the short-circuit current when the power is turned on again. Therefore, before replacing a new LED strip, be sure to find out the real cause of the LED strip. The right medicine can get twice the result with half the effort.